DIMENSIONS
 |
Uses: High electrical rating, for 250V.
Main applications: Pressure sensing on water heaters, boilers, and electrical appliances.
Membranes: EPDM, dia 22 mm. Silicone or NBR on request Double membrane on request.
Fluid: water or air
Fitting: Plastic
Pressure: positive
Housing: PA66, UL94 VO
Contact: SPDT, snap action. NO or NC contacts available with
MOQ
Electrical rating: Depends on microswitch operating force that is linked to the electrical rating - Standard rating micro-switch (medium and high pressure calibration only): 16A 125/250VAC;1/2HP 125VAC;3/4HP 250VAC - High rating micro-switch (medium and high pressure calibration only): 2HP 240V, 21(8) A 240V (UL, CSA VDE switch) - Low force micro-switch (set points less than 150 mbar): 1/4HP 6(1) A 240V ( UL, CSA VDE switch) - On request: up to 25A 250V
Action: momentary.
Set point calibration: factory calibrated and sealed, not field adjustable
Set point calibration limits: from 50 to 1500 mbar
Electrical connection: 6.35 x 0.8 mm quick connect terminals
Maximum pressure: 4 bars (58 PSI)
Ambient temperature limits: 0 to 85°C |
Available pressure inlet fittings 1
 |
 |
 |
 |
 |
 |
References ( with SPDT contact): |
Pressure inlet |
Standard rating micro- switch
(Calibration : 800 mbar) |
Low pressure micro-switch
(Calibration 150 mbar) |
High rating micro-switch
(Calibration 800 mbar) |
1/8’’ NPT |
ZQ2K28U1UH000000 |
ZQ2728U50A500000 |
ZQ2K28U6UH000000 |
1/4’’BSPP |
ZQ2K2QU1UH000000 |
ZQ272QU50A500000 |
ZQ2K2QU6UH000000 |
M10 x 1 |
ZQ2K2MU1UH000000 |
ZQ272MU50A500000 |
ZQ2K2MU6UH000000 |
Snap in fitting, 2 grooves dia 7.8 |
ZQ2K2TU1UH000000 |
ZQ272TU50A500000 |
ZQ2K2TU6UH000000 |
Snap in fitting, 1 groove dia 10 |
ZQ2K2ZU1UH000000 |
ZQ272ZU50A500000 |
ZQ2K2ZU6UH000000 |
Snap in fitting, 1 spout dia 6 mm |
ZQ2K2AU1UH000000 |
ZQ272AU50A500000 |
ZQ2K2AU6UH000000 |
|
Other set point values: replace
H00 in the product reference by
the requested value in mbar |
Other set point values: replace A50 in the product reference by the requested value in mbar |
Other set point values: replace H00 in the product reference by the requested value in mbar |
|