Application
The most simple flow switch with magnetic pull-back. Recommended mounting position is on horizontal pipes, but can be mounted in any position. For water flow detection on dia 25 to 100mm water pipes
Main features
Functional principle:
Balanced magnetic pallet mounted perpendicular to the flow and activating a reed switch through the wall. The return of the pallet is made by magnetic action, without spring. No seal or liquid can pass between the piping system and the electrical contact. Suitable for corrosive water pools and spas and salination chlorination and bromination systems.
Must not be used for water containing magnetic particles or high viscosity liquids, which block the movement of the pallet.
Adjustment: there is 2 adjustment ways on this model
- By cleaving the paddle
- By means of the adjustment screw located under the protective cover. This setting must be carried out only by professional, qualified and trained personnel, as a too low setting can produce an insufficient pull-back force and malfunction. This adjustment is designed for single use and can be sealed.
Main housing material: Polypropylene, resistant to ozone and water disinfection products, usable with potable water.
Union nut material: High mechanical strength fiber glass reinforced PA66.
The type without nut is designed for snap-in assembly on plastic and stainless steel fittings. (see section 8 of this catalogue)
Paddle: Polypropylene, 15 mm width
Paddle shaft: Titanium, providing an outstanding corrosion resistance, and improved mechanical live
Electrical rating: Max 1A, Max 70W, Max 250V, resistive load. Use on inductive circuits reduces electrical rating. We recommend to protect the reed switch with contact protection device when used in inductive loads.
Electric contact type: Normally open, closes by flow rise
Liquids compatibility: For use with clean water and liquids without magnetic particles and without chemical incompatibility with polypropylene and titanium
Nominal pressure at 20°C: 1MPa (PN10).
Nominal diameter: Can be used on 25 to 100 mm internal diameter pipes
The paddle is cleavable and can be cut at various lengths upon pipe diameter. There are cutting lines numbered 1 to 10 every 5mm.
Recommended mounting position: On horizontal pipes. Mounting in other positions slightly modify the calibration
Water pipe connection: On male ¾" fitting. NBR gasket is supplied with the product.
Recommended torque: 7Nm
Liquids temperature range: 5 to 80°C
Ambient temperature range: 5 to 50°C
Ingress protection: IP65
Electrical connection: 2 × AWG24 (0.2mm²) cable, PVC insulation, T80°, style UL2464.
Installation instructions:
- Check carefully the paddle orientation: The arrow on housing must be exactly parallel to the pipe
- A 5 mm minimum gap must be respected between end of the paddle and tube wall opposite to the fitting.
- We recommend the use of nozzles of length less than or equal to 18mm between the gasket seat and the inside of the tube and with an inner diameter greater than or equal to 20 mm, to avoid blocking of the pallet.
Accessories: ¾" male PVC saddles for DN40 to DN100 (OD) PVC pipes, and other fittings: see section 8 of catalogue N°6.
Options: cable with connector or terminals, other cable length, nickel plated ¾" BSPP union nut.